What to look for in a quality window tinting installation

Quality window tinting

What Is A High Quality Window Tinting  Installation?

Despite being the nicest looking vehicle around complete with customized hoods, mufflers, stickers and everything, it only takes a bad window tinting job to spoil its whole look. The obvious and very noticeable output of a bad window tinting job is apparent, especially to car enthusiasts. 

More importantly, it can affect some aspects of its performance in blocking theharmful effects of sunlight. Plus, the likelihood of premature peeling and bubbling is high which have negative effects in its appearance and performance. 

So it’s important to know whether your vehicle has undergone a good or bad window tinting job. If proven that the latter is the case, you must protest your claims at the auto tinting shop that serviced you and have them replace it immediately, without additional cost. 

Here are the telltale signs to look at to determine whether you have a bad window tinting job:

Evident Gap and Uneven Lines

The first thing to look at is the window edges. Check for big gaps between the window films and the line of cut of the film. If big gaps are present and the line of cut are uneven, it only means a bad window tinting job due to poor workmanship. 

Also, the line of cut of the window film must be seamless enough without ragged cuts and should fit the window section snugly.

Purple Tint

Purple tint appear only in low-quality window tint films due to UV exposure. Seeing a purple-ish window tint film suggests that your auto tinting shop had used an inferior material.

Appearance id Bubbles

The appearance of bubbles is caused by two reasons, both of which concerns the workmanship of installation and quality of window films used. 

In terms of workmanship, bubbling only appears if the prep work on the windows is not done properly. A good prep work must remove all dirt and foreign material as to provide a suitable adhesion surface for the window film. Even though you have the best window films to be installed, a bad prep work will always guarantee appearance of bubbles. 

In terms of quality, bubbles will appear when low-quality window films’ adhesive starts to break down prematurely. When this happens, air will enter the gap which will bulge even more — forming unsightly bubbles.

Window Film Failure To Stick To Dot Matrix 

The dot matrix are basically textured surface for the shade band to stick to the front windshield. This textured surface however is difficult for window tint films to adhere to. A good auto tinting shop will have ways to overcome this issue and install the window films with ease. 

If the window film isn’t installed properly, you will notice broken lines and bubbles at the dot matrix.

Bubbling at Defroster Wires

Just like the dot matrix, defroster bars are also textured in a way that it’s elevated from the surface of the rear window. This window feature makes it difficult for window tint films to adhere to. However, reputable auto tinting shops have no problems installing window films at defroster bars. 

If the window film isn’t installed properly, there will be gaps at the defroster bar without adhesive. These gaps are the places where bubbles form and becomes larger over time. 

Find Your Own Reputable Auto Tinting Shop

You’re maybe wondering, if I’m guaranteed a good window tinting job from reputable auto tinting shop, I won’t be doing any of those things outlined above. That’s true, but it’s always better to know more. Knowing more gives you certain advantages given different circumstances. 

However, if you do are looking for a reputable auto tinting shop, we at Flying Window Tinting can guarantee a good window tinting job, removing the likelihood of you inconvenienced by bad window tinting job. 

Flying Window Tinting have years of experience servicing thousands of customers yearly. We offer smart solution, so expect it done right the first time. Call Flying Window Tinting for more information!

Visit Us At:

  • 187 South Semoran Blvd., Orlando, FL 32807

Services Offered:

  • Window Tinting
  • Window Tint Removal
  • Headlight Cleaning
  • Vinyl Graphics Installation

We Serve These Locations:

  • Orlando, FL
  • Winter Park, FL
  • Alafaya, FL
  • Azalea Park, FL

How to Remove Old Window Tint that has Gone Bad?

How to Remove Old Window Tint that has Gone Bad

Why does Window Tint Go bad?

There are two things why window tint goes bad. The first one is window tint is made up usually of two to three separate layers of film. One layer is the color film another is a clear coating to protect it from scratching and when the window tint goes bad they start to separate. The second reason why window tinting may go bad is that the glue goes bad due to excessive heat over time. The chemicals will break down then the glue will start to Bubble. So when you see cars bubbling. It’s not the window tint Orlando that’s bad it said the glue on the window Orlando. Are you looking for some “best car window tint near me”? Check out the Orlando Flying Window Tinting.

What has to be removed?

To clean the old window tinting to get the window back to the original condition. You have to remove the window film first and then the second part is removing any glue that may stick to the glass. The first part is usually the hardest because if the window film is really bad it might want to come off in very small pieces if it’s not on too long usually comes off in one piece which makes your life a lot easier

How long before Window Tint Orlando goes bad?

There are a couple of things that determine how long are window tint will last before going bad.  Some factors that will determine that is 1st  the quality brand of window tint that you purchase. The better the brand the better the raw materials are. If you get a really cheap window film that says made in China usually they go bad very quickly because they use cheaper quality materials to keep their cost down while you use some American brands like 3M or Llumar window tint they use the latest quality material and them last much longer. Second, it depends on the temperature of where you live if you live Up in Detroit window tint will probably last forever, if you live in Florida or Arizona the Heat will reduce the lifespan of the window film.

The third factor that will determine how long your window film will last is if your car is a park in the garage or during the day it’s parked outside directly in the sun. If it’s parked inside a garage the life of the car will lot longer if it’s parked where you work and in the sun 8 to 10 hours directly every day.

The lifespan will shorten, So the best thing to make your window tint on your car last longest is to  buy a brand name window film with a good warranty and also try to keep it out of direct sun during the day if you can be in a garage may just park it under a tree or in the shade,

Why is it so hard to remove old tint

The reason why auto window tint is so hard to remove as because when the material starts to break down I need trying to pull it off and breaks into small pieces and then he said makes it harder to pull off because it sticks to the window.   When you tried to pull the old window tinting that comes out in little pieces.

Will you be able to save your defroster wires while removing the tint

The biggest concern people have about removing window tint themselves and not getting a professional window tinting job you do it is if they will be able to save their defroster wires. In the South, defroster wires are not too important but as you go further north where you get a lot of frost in the morning it is very important.

Here at Flying Window Tinting, we start off with the side doors and that will use you tell us how bad the window tint will be to remove. If the side window comes off in small pieces we know the chances of the rear defroster not working may increase it’s only happening to maybe 20% of the cars.  Usually, really bad window tint has probably been on over 12 years anything under seven years usually is easier to come out depending on the brand. To find out if the window tint is  good quality or a cheaper quality window tinting in Orlando just try the small as a window on the side first and that you would usually tell you whether the film will come off easy or hard

3  ways to remove window tint

1- Using a razor blade

Using this method is usually the hardest want to do and takes much more physical energy. What you basically doing is using a spray bottle with soap and water and some small scraper blades you wet the window with it in and start to scrape off the film like how you scrape paint off of the glass. As long as you keep the window really wet and soapy it will not scratch glass a disadvantage for this process is that if you have a defroster wire on the back of your window it will not work if you scrape it

2-Soaking it with water using a banking system

The 2nd process is to soak it in grease remover like 409. They also make professional chemicals that you can use .you get a black garbage bag and cut it out on the outside of the rear window to the shape of the glass that is clear.  Then soak the window with the chemical and put the black bag over the tint on the inside. Then every 20 minutes keep re-soaking it.

After then try to peel the window tint off the window if it continues to keep sticking you need to soak it until it releases smoothly. The hotter the outside the better it is I recommend doing it with the temperature over 80 degrees or put a heat lamp on it. The heat speeds up the chemical to absorb through the window tint.

 3-Using a professional steam machine

this third process needs a steam machine. Professional window tint shops t have Steam Machines worth around  $1,000 but you can also use inexpensive clothes steamer. What you do when you start peeling the corner and steam the tint. The heat from the steamer and the moisture usually weakens the glue and keeps the Window tinting Orlando together. It’s also good to do it outside in the sun the warmer the glasses the easier for the glue to remove.

Final stage

Once you have all the window tint in Orlando removed.  There may some glue residue left on the glass. You can now use the one-sided razor to scrape the glue but if you don’t want to damage the defroster wire on the rear of the glass. You get some 409 degreasers or grease remover and also some steel wool 0000  This is the finest steel wool you can get so it won’t scratch glass. After all the glue has gone double check in the corners to make sure no glue is hidden in the corners.

Conclusion

So finally decide which process you want to use.  Make a list of all the tools and chemicals you may need. Start early in the morning w when it’s sunny and warm. I would not do it on a rainy or cloudy day. It will be a bit time-consuming depending on how hot the weather is and how old the window tint is but in the end, it will save you a lot of money. it’s so funny oh my God.

Having Car Windows Tinting and Skin Cancer Prevention

car windows tinting

There are more than a few benefits of having Car Windows Tinting but today we’re talking about the role of car window tinting and   skin cancer prevention. A benefit that you can take advantage of by visiting us here at Flying Window Tinting Orlando.

Having Car Window Tinting and Skin Cancer Prevention

Having Car Window Tinting significantly reduces your exposure to skin cancer-causing UV rays. This is particularly important in areas like Orlando where skin exposure to UV rays from the sun is particularly high.

To give you a better understanding of the significance of the UV ray blocking power of having Car Window Tinting, here are a few facts and statistics that you may find interesting.

  • Exposure to UV rays is directly linked to the development of skin cancer.  UV rays damage the skin cell’s DNA. When this damage affects the DNA of genes responsible for skin growth, skin cancers begin. Having Car Window Tinting helps to reduce your risk of skin cancer by blocking out harmful UV rays and protecting the skin from the resulting damage.
car window tinting
uv protection sun window tinting
  • Our top of the line LLumar car window tinting film can filter out as much as 99% of UV rays with a wavelength of 300-380nm! This vastly reduces your chances of developing skin cancer due to UV ray exposure while driving!
  • The strength of UV rays that you are exposed to can influence your likelihood of developing cancer. When considering sun exposure, you are exposed to the strongest UV rays while driving between the house of 10 a.m and 4 p.m.
  • You may think that you are protected from UV ray exposure when you drive on a cloudy day but this isn’t necessarily true! According to the American Cancer Society, where some clouds can block some UV rays, others can actually reflect them and increase your UV ray exposure! This is why you should never rely on a “cloudy day” to protect you against a sunburn! This is also a great reason to install UV ray filtering car window tint that will protect you from UV ray exposure year round!
  • UV ray exposure is higher in areas closer to the equator. In the continental U.S., Florida is the state closest to the equator which means Floridians are exposed to higher levels of UV rays than residents living in states like New Jersey, for example. Fortunately, a high-quality tinted window film can reduce this exposure risk.
  • UV rays can bounce off certain surfaces and result in increased UV ray exposure. These surfaces include water, sand, snow, pavement, or grass, all of which, with the exception of snow, are regularly noted in Florida. You can protect yourself against these harmful UV rays by wearing high-quality sunscreen, sunglasses, and by investing in UV ray protection devices like Llumar car window tint! This is particularly important for Floridians who live a short distance from the beach, sandy areas, or areas with water exposure (which, let’s face it, is most of Florida!)
  • Protective clothing can help to reduce your risk of skin cancer from UV ray exposure. Living in Florida, however, you already know that wearing this type of protective covering in the peak of summer just isn’t feasible! With temperatures soaring, the last thing that anyone wants to do is put on more clothing!
  • Skin cancer isn’t the only risk that comes withUV ray exposure and it’s not the only risk that can be reduced by having Car Window Tinting. A high-quality Llumar car window tint can also reduce other side effects of UV rays including skin discoloration, decreased skin elasticity, precancerous skin changes, the risk of developing cataracts, signs of premature aging, immune suppression, and wrinkles.
  • There s a misconception that dark-skinned individuals cannot suffer negative health effects due to U.V ray exposure. While dark-skinned individuals do have a lower risk of developing skin cancer from UV ray exposure, their exposure to dangerous UV rays can still lead to negative health effects like cataracts and suppression of the immune system! You can reduce these chances by investing in high-quality sunglasses, protective sunscreen, limiting your time in the sun, and purchasing high-quality car window tint to stop a significant portion of those UV rays from sneaking in!

Ready to Get Car Window Tinting ?

If you’re in the Orlando area and are ready to take advantage of the medical benefits of gettingCar Window Tinting , give us a call today at Flying Window Tinting Orlando at (407) 380-1202 and make an appointment with one of our professionally trained installation technicians!

This was written by Steven Hopkinson owner /operator of Flying Window Tinting.
We have been in business in Orlando same location for over 20 years
We serve the following locations
orlando
winter park
alafaya
azalea park
We also provide the following service
Window tinting
tint removal
headlight cleaning
vinyl graphics
Contact us for free quotes on your vehicle 407-380-1202